Since some time there are errors in recording rainfall.
In a typical event data comes in and then there is a lot of data following within seconds - and then there is a gap. It's possible to delete this data (a lot of data), afterwards rain/time works, but no cumulative rainfall.
Version 4y, 1 wmr200, 2 plugin-stations (collects data every 90 seconds).
Thanks.
rainfall errors
Moderator: Mattk
rainfall errors
- Attachments
-
- rain-rate.png (6.7 KiB) Viewed 2976 times
-
- rain.png (12.34 KiB) Viewed 2976 times
-
- Regen.jpg (153.42 KiB) Viewed 2976 times
Re: rainfall errors
The manual explains how to mark data as deleted on Meteohubbs "inspect data" page.
Re: rainfall errors
Marking the data "deleted" did not solve the problem, as mentioned before.
Looking through my older posts I recognized a similarity in an older topic: the last value of the rain-sensor is 114442 - the same value as in an older post. I reset the wmr200 and the value started at zero again - problem solved.
I don't know if this error occurs only on my wmr200 or this is a general failure. Since buying my wmr200 seems a little bit broken, the internal datalogger does not work and my wmr200 therefore does not run out of memory. - So maybe this is only a problem of my system.
Looking through my older posts I recognized a similarity in an older topic: the last value of the rain-sensor is 114442 - the same value as in an older post. I reset the wmr200 and the value started at zero again - problem solved.
I don't know if this error occurs only on my wmr200 or this is a general failure. Since buying my wmr200 seems a little bit broken, the internal datalogger does not work and my wmr200 therefore does not run out of memory. - So maybe this is only a problem of my system.