Acurite Bridge pressure not being logged

[jswnhart]

I switched back to the Internet Bridge from the Access and am not logging pressure data any longer.

Live Data
Sensor
Outdoor #5

Am running Meteobridge 3.5 (Jan 28 2018, build 11900), FW 1.3

My>Acurite reports pressure so the bridge is sending the data.

Any ideas. Thanks

[admin]

Can you please share the complete system messages log?

[jswnhart]

Sorry, I didn’t look at the log, just the live data. Obvious error —-
logger (01.02.2018 12:30:44): Bad thb0(0) sensor data, "sea level pressure x10" (13514) out of range [4000:13000]

The pressure correction is set to 0.000 inHg.

[jswnhart]

Bridge application version 224
Bridge boot f/w version 104

[jswnhart]

I reset the MeteoBridge and it picked up the “Indoor” sensor (pressure).
I also needed to set the bridge to “station pressure” to get the expected value.

[jswnhart]

With this configuration, My>Acurite is reading about 6 points low.
I think there is another thread addressing this situation.

[admin]

The Acurite stations are know to be "creative" on pressure adjustment. I cannot recommend any Acurite station when you look for reliable pressure data.