MBPro red display error. **solved**

[jackT]

Hi,
I updated today my MBPro red to the last version (from the April 7 2020 firmware version), and I observed problems with the display.
For example, using the built-in, not modified , BIG-scroll-ISO.dsp display template, the temperature, humidity and pression pages have "garbage" characters overwriting the value of the parameter (see attached image), and there is the following errors in the log :

Code: Select all

oled (15.06.2020 07:48:11): Unknown command: #if#5.0#then##pline 105 43 20 55
oled (15.06.2020 07:48:11): Unknown command: #else##fi##disc 105 43 4
oled (15.06.2020 07:48:57): Unknown command: #if#1.1#then##pline 105 43 20 35
oled (15.06.2020 07:48:57): Unknown command: #else##fi##disc 105 43 4
oled (15.06.2020 07:49:04): Unknown command: #if#5.0#then##pline 105 43 20 55
oled (15.06.2020 07:49:04): Unknown command: #else##fi##disc 105 43 4
oled (15.06.2020 07:49:09): Unknown command: #if#5.0#then##pline 105 43 20 55
oled (15.06.2020 07:49:09): Unknown command: #else##fi##disc 105 43 4

[ConligWX]

I take it you have rebooted again just in case the firmware was only updated partially or somehow corrupt? failing this, email Boris directly.

info(at)smartbedded.com

[Mattk]

How old is the MB and how long has that screen been running?

[jackT]

The MB is about 2 years old, and a modified version of this screen has been running since the installation.
I observed this problem after the last update with my modified template, and to rule out a possible bad syntax in my own template, I switched to the build-in template that is showing the same problem and the errors in the log.

[jackT]

I take it you have rebooted again just in case the firmware was only updated partially or somehow corrupt? failing this, email Boris directly.

Yes I rebooted several times. I sent therefore a email to Boris. Thanks

[jackT]

For your information, a new update is now available that corrects this problem.