Meteohub and Weather Display

[HeinrichH]

I noticed that in the data export screen to WD there's no possibility to export UV and Solar data.
Is that a hidden option of don't it exists?

I want to know this because on my remote locatieon I use two weather stations, a Davis Vantage Pro with UV and Solar and a RFXcom receiver with a lot of OS stuff attached to it.

I noticed that version 4 has multi weather station capabilities so if MeteoHub supports the data for WD I need I don't have to run virtual weather station to double the Davis data and I can use MeteoHub to feed WD with data.

[skyewright]

I noticed that in the data export screen to WD there's no possibility to export UV and Solar data.

Have you looked at this alternative route for getting Meteohub data into WD?

[HeinrichH]

Thanks for the tip, does WD then collecting all the data thats Meteohub is collecting? Also all the extra sensors?

[skyewright]

Thanks for the tip, does WD then collecting all the data thats Meteohub is collecting? Also all the extra sensors?

Essentially WD sees a copy of all sensor readings that Meteohub collects.

thb0 => Indoor temp/hum & baro
wind0 => Wind
rain0 => Rain

Other wind and rain are ignored (as WD only expects 1 of each).

th0 => Main outdoor temp/hum
th1-9 => Extra sensors (I'm not sure what would happen if you had a th10!)

I don't have a UV sensor but I believe that is also handled.

N.B. If you have temp only, then WD sees th1 and t1 as the same sensor, so keep the numbering separate in Meteohub, e.g. I have th0, th1, th3, th5, th6, t7, t7 and t9!

th0 does not conflict with thb0.