Meteobridge Pro Display Settings

[Udo]

Hi, I‘m new here and sorry if my question below has been answered already.
How can I set the display to show Wind speed and Wind guest in Kn.
After reset to factory settings this setting got lost
The display do only show two vertical bars moving from the edge to the middle.


Thanks
Udo

[admin]

What you see is the screen saver. You need to define a display event on "Events" tab.

[Udo]

How do I define a display event ?
Can not find such a sevice on event tab.
Thx Udo

[Mattk]

Events tab > Select Service [Display], Select Event Type and Save
Select Standard Message (from the display option list, what you were using prior to factory reset should show in list)

Templates (including display / .dsp files) live in the \\your.mb.pro.ip\templates folder, Display files have an extension .dsp

Also just check your Display Control setting on the System>Administration tab

Also be aware that continuously running the oled display will eventually cause screen burn-out. If you can get the same information via a different event then all the better.