http://192.168.1.77 No Response - Blank Screen

[doublecheese]

When I type http://192.168.1.77 on my browser, I normally get connected to my meteohub set up page.

However, today I only get a Blank Page instead, I know that Meteohub is working as it's updating all the values on Wunderground and Weather Display Live.

Can somebody tell me why I'm getting a BLANK PAGE rather than my usual MeteoHUB Set Up page ?

I have rebooted the MeteoHub a several times by unplugging it off electricity and replugging it.

[vecerapl]

ROUTER you using? If so, try and 192.168.1.1. or 192.168.1.10x (where x is a number from 0 to 5)

[doublecheese]

Hi,

I'm using Linksys Cisco WAG160N

Nothing helped , but then I went to my web browser history and used the following adress than it worked .

http://192.168.1.77/cgi-bin/meteohub.cgi

Before I was using only the numbers, but now it works only with above adreess. I don't know why.

But it works and I'm happy ...

[skogvaktare]

When I type http://192.168.1.77 on my browser, I normally get connected to my meteohub set up page.

However, today I only get a Blank Page instead, I know that Meteohub is working as it's updating all the values on Wunderground and Weather Display Live.

Can somebody tell me why I'm getting a BLANK PAGE rather than my usual MeteoHUB Set Up page ?

I have rebooted the MeteoHub a several times by unplugging it off electricity and replugging it.

Hi!

I´ve got a similar problem. The MeteoPlug is not reachable. Network is tested and ok (the little orange LED at the Plug´s ethernet plug is also blinking)

Router prefs didn´t change. But there´s no contact to the plug.

Neither the adress "http://192.168.0.99/cgi-bin/meteohub.cgi" nor the adres "http://192.168.0.99" bring me to the data.

Did anyone know a solution?

Christian

[admin]

what IP does in blink to you during boot?

[skogvaktare]

Hi!

I already send you an email at this moment.

I don´t know. How do I see this. I have to study the manual for the code first

[skogvaktare]

Everything i fine again!

There was a problem concerning the boot-process. After flashing the Plug again, the Meteoplug is running with the old SD-Card´s system! Unfortunately the meteohub doesn´t read out the VP2´s logger, so there´s a little lack in the datas.

Thank you for the help, Boris!

[doublecheese]

Hı Borıs and others

I can not see my meteohub page agaın !!! I did not change anything at all, all settings are the same but when I type in the meteohub address I can not conncet to my meteohub. I always get a blank screen

What can I do ?