UVI has no value in clientraw.txt (and WDL)

[wouterk]

Hi,

I have a UV sensor attached to my WMR200 connected to meteohub (version 4.7d). On the WMR console I get a reading from the sensor but in the clientraw.txt it has no value.
Valuenumber 79 (in the clientrax.txt) should have a value from the UV sensor but it has a "-" as a value. WD Live does not display a value either. When I alter it manually is WD Live displays the entered value.

Can someone tell what I can do so that the clientraw.txt contains the correct value for the uv sensor?

Regards,

Wouter.

[YJB]

Hi,

Did you select the UV sensor in the WD Live setup page?

[wouterk]

Hi,

Yes I did. I configured a uv0 sensor connected the the sensor type meteohub displayed by itself. When I check the sensors page in the meteohub admin pages I get a reading from the sensor. Also, meteohub generates a graph from the UV sensor.

Screen shot 2011-03-11 at 16.00.47.png (14.62 KiB) Viewed 2893 times

[wouterk]

Hi,

Looking again at the reply from YJB I checked the setting again and for some reason, must be me ;-), the setting was gone.

@ YJB ; Thanks for the hint. Hope the sun will shine again so I can see that it works.