meteohub.de

Not directly as my site is configured to store everything in imperial and Meteotemplate just defaults to whatever the units in use are for exports. I will poke around and see if there is an option buried in there somewhere that won't blow up my site to temporarily override this. Otherwise I can run ...

Hello All,

Building out my replacement Meteobridge and tried to import data via the IMPORT FILE in 'Meteotemplate' format. My Meteotemplate file is in Imperial and my Meteobridge has the option under Station>Settings>USE IMPERIAL UNITS checked. Still when I import data, Meteobridge is treating the ...

To update this post, I did get the serial cable to monitor the boot and with the Meteobridge image I get nothing. Any other image I try works fine, just not the image I downloaded for my 3B+. So at this point I have given up and converted this 3B+ into my new Homebridge device which is working just ...

I don't have a cable to monitor via serial (not yet... just ordered one). I get nothing when trying to monitor the HDMI connection, through I am not convinced the boot is getting far enough to even activate the HDMI port. I just immediately get that blinking green light sequence, 4-long, 7 short ...

I am trying to setup a new RPI unit (a 3B+) but whenever I try to image the SD card (a recommended SDSDQED-008G-XI) the RPI will not load. I have tried a separate SD card with same results. I have also imaged the card with other Raspberry PI images and those all will successfully load, so only when ...

Well duh!

All the searching I did for Password Reset and strangely the answer was there on basically page one of the instructions. I have successfully reset things.

Yes, overly complex. Did not pay close enough attention to my password manager and what random password was being generated. 20 ...

I am setting up my new Meteobridge and reset the password from the default. I used a random generated password that contained a symbol and was set to default to 20-characters for new password (did not realize the default was set so high). When I clicked save I got a warning about HTTP only allowing ...