meteohub.de

Marking the data "deleted" did not solve the problem, as mentioned before.
Looking through my older posts I recognized a similarity in an older topic: the last value of the rain-sensor is 114442 - the same value as in an older post. I reset the wmr200 and the value started at zero again - problem ...

Since some time there are errors in recording rainfall.
In a typical event data comes in and then there is a lot of data following within seconds - and then there is a gap. It's possible to delete this data (a lot of data), afterwards rain/time works, but no cumulative rainfall.
Version 4y, 1 wmr200 ...

I'm using Meteohub since 2008 and my 4 GB SD-Card is getting full.
The solve this problem I see two possibilities:
a) moving raw-data somewhere else (+) free space, faster recalculation after e.g. data-correction (-) can't access this data anymore with Meteohub
b) getting a larger sd-card (+) all ...

worked - thanks!

Hi!

There was heavy rain and something caused my Sheeva to stop collection rainfall data. All other sensors worked fine (wmr200). About 2 hours after the fail I recognized the problem and restarted the data-collecting-process. Rain0 was found again and nearly everything was fine.
Except that there ...

Hi!
In May there was a failure of the rain-sensor and it didn't send (or wasn't received) data for some hours. After reseting there was a huge amount of rainfall calculated. I had a look on the raw-data and found one line with obviously corrupted data. I deleted this line and made a recalculation ...

I'd like to display data like the daily rainfall from the day before or month before. There is a way to do this in the graph-section. Is it possible to show this data in html-templates? Thanks.

I guess pwd-saving is not the problem. There is also no question when I delete those settings in firefox, nor when I change the password in meteohub. It's the same situation on any computer I tried until now.

Actually this does not concern this update in special, but since ??? I miss the password-question when entering meteohub.
Was there a change, is it my system or is there an error in one of the new updates?

Running 4.1, WMR200, NSLU

I think that wind chill calculation still does not work, no mather if data calculated by meteohub or taken from the WMR.

sea-level-pressure works fine!

Thanks!

I got the same problem than darren7303. There is no historical data in dashboard nor than in my html-template.
I think that there might be a problem in the re computation of the data. At re computation my NSLU used to calculate about 450 records/sec. On rc7 and rc8 there were about 1500 records/sec ...

WMR200, rc6

As it got colder I recognized that wind chill is not displayed in graphs either.
There is still the problem with no sea level pressure in graphs (correct sea pressure displayed in dashboard).
Both values are calculated by meteohub, but there is no difference with data taken from the ...

No sea pressure level graphs

I wrote before, so I didn't want to double.

WMR200, rc4, via altitude

On rc3 I tried other settings, which didn't work neither. After changing there is always a recalculation, which takes a lot of time, so I stopped trying other settings on rc4.

Thanks!

Hi!

Sea pressure graphs are still not working; at least not at my meteohub.

Peter.

As usual: Great work within a short time! Thanks!

Now there is a UV-Sensor and wind chill correct calculated and windsensor ok.

Still not working is a graphic with pressure at sea level. It shows the same graph using thb0 and thb0-sea. Sea level pressure is calculated by meteohub and shown ...