meteohub.de

I have reviewed the logs.
The meteohub log indicates no errors are occurring.
The system log doesn't indicate any associated errors.

The alarm log indicates on a regular basis that the weather underground cannot be reached. I have set the upload for 180 seconds. Whereas the successful uploads occur ...

I'm going to have to get on site to be able to troubleshoot this further. It may be up to 2 weeks before I get there. I'll reply at that time with as much detail as possible.

It is Meteohub/Weatherhub on a Sheevaplug with the latest 4.9v I believe.

My uploads to weather underground have started fail.

Since 2008 it has been uploading every 6 minutes or so. This past June it started to only upload every several hours or so and then stopped completely. After about 6 weeks it seemed to resume on its own. This was after I pulled up the web ...

My power has just been restored from another power failure. Usually after the Meteohub (NLSU2) is powered back up all works fine. Except this time.
The system will not data log and therefore no current weather data.

The meteohub log that appears to be relavent;
logger (18.08.2012 17:00:37): station ...

Thank you for the info. I'll play around with these numbers.

I am using a Davis Vantage Pro 2 weather station with a Davis rain gauge heater installed. Snow is melted and measured as liquid equivalent. Has anyone out there had any experience or used a formula for converting the liquid equivalent into snow depth?

Success! The hang on the weather station page was confusing me. I stopped the browser after about 10 minutes and refreshed the page and all saved data remained. This then made the sensor page function properly and then it was clear sailing from there.

I'm now back in business. I used version 4.6n

Thank you. I have been following this guide and everything seems to get hung up at the weather station page. I add a Davis Vantage Pro2. It shows available USB Serial and USB HID. However in the drop down menu for type of connection only USB serial is available. Should it not be USB HID?

When I ...

Hi again. I have just upgraded to the v4.6m. That process seems to have worked fine. Now I am having problems adding the weather station and sensors. Doesn't seem to want to do this and I keep getting a warning "Weather station does not have a sensor assigned on "Sensors" page"

Do I need to wait ...

Thank you. I will proceed with the m version

I currently am running an NSLU2 with software version 3.3 which I upgraded after having to replace a faulty usb stick in February 2009. After running flawlessly since that time I figure I should upgrade to the latest software. Can I go directly to the latest version 4.6n ?

SUCCESS! All systems are up and running again.

Thank you for all your assistance in helping me resolve this issue.

***********************************************

I did use DiskImage but I was not sure of the mode.
I just finished redoing the stick and I am now in.
Obviously I didn't select the ...

I have copied the meteohub runtime environment onto a Kingston USB flash memory drive, 4gb following the steps in 1.1.3 of the manual. I have used the Windows XP method.

I have then started meteohub, however I cannot access the meteohub application. It would appear that my router and network drive ...

Further to the set up of a new memory stick.

Should I also update the firmware?

I am not sure what version I have unless the linux kernel: 2.6.21.7 is identifying the version.

I have a new stick ready to go and will be re-installing the system tomorrow.
[Kingston Datatraveler 4GB USB drive]