My Meteobridge has no outdoor sensor data. **solved**

[captgadget]

showing up. Indoor but no outdoor. Any suggestions. I'm using the Davis Weather Link Live

[wvdkuil]

Did you check if the IP-address is valid
Is the correct transmitter selected from the dropdown
It would be helpfull if you posted a screenshot of the Meteobridge tab were you setup the WLL as your primary station.

You should also check if the WLL is correctly functioning using this command in your browser
http://192.168.0.128/v1/current_conditions
Replace 192.168.0.128 with the IP-address of your WLL.
The data returned should contain texts such as

Code: Select all

"temp": 50.6,"hum":86.2,"dew_point": 46.6,
"wind_speed_last":0.00,"wind_dir_last":0,"wind_speed_avg_last_1_min":0.00,

Succes, Wim

[captgadget]

I used your functioning link with my info and everything comes back in good order. What I find strange is that when I select WLL to upload to WU all the info shows but if I check my devices it shows the station offline. https://www.wunderground.com/dashboard/ ... wx_pwsdash So WLL is sending to WU but I'm guessing since my station is offline that's why it doesn't work in the Meteobridge. Appreciate your insight.
"temp": 88.9,"hum":61.5,"dew_point": 74.0,"wet_bulb": 76.9,"heat_index": 98.1,

Screen Shot 2021-10-23 at 3.23.02 PM.png (147.88 KiB) Viewed 1740 times

[captgadget]

Screen Shot 2021-10-23 at 7.30.08 AM.png (293.4 KiB) Viewed 1740 times

Here's what I'm referring to when I say there is outdoor sensor just indoors

[wvdkuil]

I used your functioning link with my info and everything comes back in good order. What I find strange is that when I select WLL to upload to WU all the info shows but if I check my devices it shows the station offline. https://www.wunderground.com/dashboard/ ... wx_pwsdash So WLL is sending to WU but I'm guessing since my station is offline that's why it doesn't work in the Meteobridge. Appreciate your insight.
"temp": 88.9,"hum":61.5,"dew_point": 74.0,"wet_bulb": 76.9,"heat_index": 98.1,
Screen Shot 2021-10-23 at 3.23.02 PM.png

In that screenshot you did not specify which sensor sets you have.
Now only WLL integrated sensors are processed, that are inside temp/hum/pressure a.s.o.

Normally, transmitter nr 1 is the ISS (outside sensensuite). That ISS has all normal outside sensors temp, hum, wind a.s.o.
You have to add that in the second part, see attached screenshot.
You have to setup that before the Meteobridge knows were to look,

Wim

[captgadget]

Bingo!!!!!! Thank you thank you don't know how to say it in your native language but thanks a million!