meteohub.de

Thank you for the link!

After sevral reboots and waiting i rolled back to 4.2 and the issue went away.


Think i just made up my mind to have it run on this version and not the latest at reboot.

I started getting this tday while reporting to WU. All others are reporting ok this has been going on for about 2 hours any thoughts? My neighbors station is up fine.

2020-06-09 18:36:51 Error: 2020-06-09 18:36:41 Read error (Connection timed out) in headers. (no more tries)

The indoor humidity from the MB Pro is showing 10% and outdoor 25% right now. Yesterday the MB PRO indoor was max 30% and the outside was max 53%. This is with the windows open all day so it should be very close I would think.

weather.png

This current, today high/low and yesterday highs/lows ...

Understood! The issue is im in a very very DRY environment humidity is around 15 - 20 % all the time. We get 16 inches of rain a year average. Im just seeing 10 points higher with the new ISS vp2. If I were to set the VP2 to retransmit and not connect directly to the ISS i will get the same reading ...

From the meteobridge site it states this :

"When you have a humidity sensor that only reports values from 5 to 95 relative humidity, you can stretch its values to the full range of 0-100. Value ranges are controlled not to leave [0..100] interval."

My interpretation of this is if your sensors ...

I have a vantage pro 2 and the console is reporting 75% outdoor humidity but the MB Pro live data is showing 85% outdoor humidity. I didnt think the MB Pro had an offset value one could set so im not sure whats going on. Any sugestions?

Is it possible to have both ISS sending data to the MB PR? I have them on different channels an I see the Vantage Vue coming in but nothing from the pro. How can I tell if it is even getting RF from the PRO? BTW - The VUE was my original ISS and the pro was given to me.

Anyone know why this is happening and if its an issue or not? I dont really see any missing data on Weather Underground for my station.


wnetd (03.06.2019 02:19:28): process received signal (11) and terminated: wnet_handle* < appendlog < wnet_handle < send_data* < debugmsg* < debugmsg < send_wnet ...

Correct it will not connect to the Vue. This is direct to the iss and only one

So my Vantage Vue will not connect to my MBPro for any sensors but rain. The rain connects and it’s -49db so it’s a good signal. Anything I can do? I have tested the signal setting on MBPro from -90 to -60 and I’m continuing lower but I don’t think that’s it.

My weather station has been working ok but a few weeks ago went offline. If I reboot it by removing power it will come online for a bit but then goes back to not reporting. Can someone point me in the right direction?

okay so im right in the middle of hurricane irma and meteobridge says 14 + mph winds but WU is at 8.6 the station is taking winds so so so much more than reporting.. any thoughts???


https://www.wunderground.com/personal-w ... 18#history


davis vantage

I was uploading fine to Ambient Weather and now I see this error when I look in Live Data. When i go back to the weather nets tab its no longer listed. If I reboot the MBPRO and go right to live data its says it was successful and has green check. I login to my dashboard and i see the current ...

From what I have read here on the forums the MBPRO Red works like this:


http://www.davisnet.com/product/envoy8x/