meteohub.de

It is working again spontaneously now after having done nothing for hours. The power supply is difficult to connect (doesn't fit well), and attaching the plug is tricky. It feels like it isn't seated properly behind the opening. I gently moved the plug, and then the green, orange, and red lights ...

When starting up, the green light comes on, but nothing else happens after that; the red light does not blink either.
Because RF reception was poor, even with an external antenna, I switched the motherboard to Wi-Fi to get closer to the VP2 and later back to Ethernet, due to glitches in uploading ...

Hello, my Meteobridge PRO2 spontaneously restarted after a few minutes following a reboot and then froze, while the green LED light is on but nothing else happens. I unplugged it from the power and restarted it a few times, but it froze every time while the green LED light is on.

I followed your advice and set the sensitivity to -80, then restarted, after which all data from the ISS were displayed again. :D
The distance to the ISS is approximately 16 meters and I am using a WH-MBpro-GP Ground plane antenna for MBpro SKU WH-MBpro-GP.
Thanks.

I tried a previous release, but this also gives no data, neither on the PRO nor the PRO (red).
Regarding MAR 25 2026 see attachment

After an update (reboot) of the Meteobridge PRO2 to 6.3 (Mar 25 2026), the values ​​from the Davis weather station are no longer displayed. Neither is the internal temperature. After startup, the orange LED flashes for approx. 10 minutes and then stays lit constantly. The red LED does not light up ...

After consultation with the webshop I sent the MB

The IP address changed spontaneously, and then I tried to fix it. This probably used an IP address that was already in use.
I waited until the yellow LED flashed rapidly and then tried pressing the button in the pinhole with a paperclip, but that didn't work: I didn't get the options described in ...

The MB PRO2 cannot connect to the network.
When I start the MB PRO2, the green light turns on and the orange light flashes rapidly.
After a few minutes, the message "no network found" appears.
The PRO2 is connected to the network switch by cable. After a while, the orange light turns on constantly ...

Corrections tab History/Edit Hour Data. According to Tutorial Cleanup of History Data

After I made corrections (in accordance with Pro Tutorial) to some daily precipitation totals, both the monthly total and the annual total have changed, but no longer correspond to the total precipitation as shown in the History / Edit Hour Data tab. The monthly total indicates double the amount and ...

There appears to be a malfunction in the transmitter board.
I assumed that if the signal is insufficient, this will be indicated permanently in red on the raw sensor data tab. Apparently the data disappears from the overview of the tab after a while when no more signal is received.

So problem is ...

In the Station / Primary Station tab I have configured an added sensor #3.

Schermafbeelding 2020-10-20 om 11.33.13.jpg

This always worked fine. Now the station is no longer visible in the Live Data / Raw sensor data tab for inexplicable reasons.

Schermafbeelding 2020-10-20 om 11.34.50.jpg

I ...

Data registration and therefore also data transmission stopped again on September 10 at about 13:00 hour.
Two times in a few weeks. That is not normal.
What could be the cause of this?

After a restart due to a power cut, everything works again.

BeBe